![]() Instead I used two small flat screwdrivers and inserted them into the two larger holes on each side of the hose-end clip. ![]() A Pod Filter On A Vt Commodore Drivers And Inserted To remove the hoses some people say to squeeze them, possibly using pliers, and that they break easy. The filter is held in place with a plastic clip which is easy to remove, but you are probably best leaving that until after the hoses have been removed. I backed the car up on to ramps so that there was plenty of room to work in, but you dont necessarily need to lift the car at all. ![]() I did this by leaving the car running and then pulling out the fuel pump fuse.įirstly, if you arent sure where the fuel filter is located, it is accessible from underneath and behind the car, just next to the differential and on the right side of the car. Optional 8 rib pulley kit and Gilmer rear drive belt kit available.īefore you start on this job you should relieve fuel pressure.
0 Comments
Leave a Reply. |